SonyTABLETOPSTAND(SU-42FW)

閲覧数1,058
ダウンロード数0
履歴確認

    • ページ数 : 2ページ
    • 全体公開

    資料紹介

    2-342-348-03 (1)
    Tab letop Stand
     2004 Sony Corporation Printed in Japan
    SU-42FW
    安全のために
    ソニー製品は安全に充分に配慮して設計されています。しかし、まちがっ
    た使いかたをすると、転倒などにより死亡や大けがなど人身事故につながる
    ことがあり、危険です。事故を防ぐために次のことを必ずお守りください。
    • 安全のための注意事項を守る。
    組み立て説明書
    Mounting Instructions
    Instructions de montage
    Montageanleitung
    Instrucciones de montaje
    Instruzioni per il montaggio
    安装说明书
    お買い上げいただきありがとうございます。
    安全のための注意事項を守らないと、人身事故になることが
    あります。
    この組み立て説明書には、事故を防ぐための重要な注意事項と製品の取り
    扱いかたを示してあります。この組み立て説明書をよくお読みのうえ、製
    品を安全にお使いください。お読みになったあとは、いつでも見られると
    ころ

    資料の原本内容

    2-342-348-03 (1)

    スタンドに取り付けたディスプレイにぶら下がらない

    外形寸法 / Dimensions / Dimensions

    English
    The SU-42FW is a Tabletop Stand for the FWD series Flat Panel Displays.

    スタンドが転倒して、大けが、死亡などの原因となること
    があります。

    Follow the instructions to assemble the Tabletop Stand and install your
    display to it. For more details on the applicable display units, refer to the

    Tabletop Stand
    製品の上に乗らない、
    重いものを乗せない

    組み立て説明書

    倒れたり、落ちたり、壊れたりして、けがの原因になるこ
    とがあります。

    Align the screw holes on the Main Bracket with the corresponding holes on

    500 (19 11/16)

    the Stand. Secure the Main Bracket to the Stand using the screws. A
    Use nine +K6× 12 screws (supplied).

    電源コードを傷つけない
    設置時に電源コードをふんだりはさみこまないでくださ
    い。電源コードを傷つけると、火災や感電の原因となるこ
    とがあります。

    Installing the Flat Panel Display
    Before installation, remove the Cable Cover on the display and connect all

    改造しない

    安全のための注意事項を守らないと、人身事故になることが

    改造するとテーブルトップスタンドの強度が低下し、ディ
    スプレイが転倒してけがの原因となることがあります。

    あります。
    この組み立て説明書には、事故を防ぐための重要な注意事項と製品の取り

    the cables to the Flat Panel Display.

    542.7 (21 3/8)

    お買い上げいただきありがとうございます。

    200 (7 7/8)

    Assembling the Tabletop Stand

    440 (17 5/16)

    Mounting Instructions
    Instructions de montage
    Montageanleitung
    Instrucciones de montaje
    Instruzioni per il montaggio
    安装说明书

    97.5 (3 27/32)

    instruction manual of your display unit.

    1 Remove the Cable Cover. B
    2 Put four hooks on the rear of the display in the corresponding holes on
    the Main Bracket of the Tabletop Stand, then slide the display straight
    downward. C

    扱いかたを示してあります。この組み立て説明書をよくお読みのうえ、製
    品を安全にお使いください。お読みになったあとは、いつでも見られると

    A

    ころに必ず保管してください。

    Warning

    SU-42FW

    440 (17 5/16)
    492 (19 3/8)

    メインブラケット/
    Main Bracket/
    Console principale

     2004 Sony Corporation Printed in Japan

    • Two persons should work together on the installation.
    • Before securing the display to the Stand, check to make sure that all
    hooks are properly hooked in the corresponding holes.
    • Bundle the cables and draw them through the hole on the Stand.

    3 Secure the display to the Stand. D
    Use four +K5× 25 screws (supplied).

    安全のために

    4 Route the cables inside of the Stand and attach the Cable Cover again,
    then caps. E

    ソニー製品は安全に充分に配慮して設計されています。しかし、まちがっ
    た使いかたをすると、転倒などにより死亡や大けがなど人身事故につながる

    ネジ/Screws/Vis

    スタンド/Stand/Support

    注意を促す記号

    in the Security attachments located on the upper part of the Main
    Bracket and fix the wire to a wall. F

    291.4 (11 15/32)

    • 安全のための注意事項を守る。

    警告表示の意味

    5 Anchor the Stand to a wall. Draw a wire (or the like) through the holes

    686.7 (27 1/32)

    ことがあり、危険です。事故を防ぐために次のことを必ずお守りください。

    組み立て説明書および製品では、
    次のよ
    うな表示をしています。表示の内容をよ

    B

    く理解してから本文をお読みください。

    Warning
    For details on how to protect the display from tipping over, contact your
    authorized Sony dealer.

    295 (11 5/8)

    行為を禁止する記号
    この表示の注意事項を守らないと、事故
    などにより死亡や大けがなどにつな
    がることがあります。

    ケーブルカバー/
    Cable Cover/
    Protection des câbles

    この表示の注意事項を守らないと、
    けが

    単位:mm/Unit: mm (inches)/Unité: mm (pouces)

    をしたり周辺の物品に損害を与えたり
    することがあります。
    ディスプレイのイラストは、 FWD-42LX1です。

    C

    The display unit in the illustration is the FWD-42LX1.
    L’écran illustré est le modèle FWD-42LX1.

    下記の注意事項を守らないと、

    事故などにより、死亡や大けがの原因となります。

    日本語

    フック/Hooks/
    Crochet

    転倒防止についてはお買い上げ店またはソニーのサー
    ビス窓口に

    ディスプレイのケーブ
    ルカバー/Cable Cover
    on the Display/
    Protection des câbles

    に従って、組み立て、取り付けを行ってください。 対応モデルについては、

    Suivez les instructions pour assembler le support de téléviseur et y installer

    テーブルトップスタンドの組み立て
    メインブラケットとスタンドのネジ穴を合わせ、ネジで固定する。 A

    votre moniteur. Pour plus d’informations sur les écrans concernés, reportezvous au mode d’emploi de votre écran.

    Assemblage du support de téléviseur
    Alignez les orifices des vis de la console principale sur les orifices du
    support correspondants. Fixez la console principale sur le support à l’aide
    des vis. A

    D

    フラットパネルディスプレイの取り付け

    設置は、2人以上で行う

    フラットパネルディスプレイのケーブルカバーをはずして、フラットパネル

    設置は、2人以上で行ってください。1人で行うと、腰を痛
    めたり、けがの原因となることがあります。

    ディスプレイ側にはケーブル類はすべて装着しておいてください。

    Utilisez neuf vis +K6× 12 (fournies).

    Installation du moniteur à écran plat
    Avant l’installation, retirez la protection des câbles sur l’écran et raccordez

    不安定な場所に設置しない
    次のような場所に設置すると、倒れたり落ちたりして、け
    がの原因となることがあります。
    •ぐらついた台...

    コメント0件

    コメント追加

    コメントを書込むには会員登録するか、すでに会員の方はログインしてください。